3D printing DIY-12 inch/14 inch suitable for Milwaukee 18v lithium battery DC brushless charging fan (battery not included) (spot)

It takes 18 hours to 3D print a seat that can be inserted into a lithium battery

5.0AH battery can be used for 9-10 hours (battery purchased separately)

12 inch size/14 inch

This motor adopts brushless motor, low loss, energy saving 😇 It does not heat up when it is turned on for a long time

Clean machine, excluding charger and battery

#三speed强风#Home Essentials#Decoration Essentials#Engineering Essentials

#Fengye Hardware

ABS arc-shaped reinforced battery holder, beautiful and stable, high temperature resistant, can be placed in the car in summer without deformation

1. Brushless DC motor, quiet, durable and wear-free

2. Large size, fan blade size: 12 inches, external size about 38*38*18 (cm), air volume kills all electric tool brand original fans

3. With low-voltage protection, if you forget to turn it off, it will not damage the battery. When it reaches the specified voltage, it will cut off the power directly

4. Three-speed speed regulation, battery life: If you use a 5.2 Ah fully charged battery, the first gear is about 12 hours, the second gear is about 7 hours, and the third gear is about 5 hours

5. A good helper for decoration, home, travel and camping

#Fengye Hardware